Hotpoint Ariston WMTF722HUK

Questions and Answers

B
Brian YorkAug 18, 2025
What to do if Hotpoint Ariston WMTF722HUK Washer shows 'Water tap closed'?
- M
  Mark LucasAug 18, 2025
  If your Hotpoint Ariston Washer displays the 'Water tap closed' message, check the following: Ensure the water tap is fully open and the water supply pressure is adequate. Inspect the water inlet hose for any kinks. Check if the mesh filter of the water supply hose is blocked. Verify that the water hose is not frozen. Also, inspect the safety valve inspection window of your water supply hose; if it's red, replace the hose. After resolving the issue, restart the program by pressing 'Start (Pause)'. If the problem persists, contact After-Sales Service.
M
Michelle LarsenAug 21, 2025
What to do if my Hotpoint Ariston WMTF722HUK vibrates during the spin cycle?
- K
  Kim KnightAug 21, 2025
  If your Hotpoint Ariston Washer vibrates excessively during the spin cycle, make sure the washing machine is level and the feet are properly adjusted according to the installation instructions. Also, ensure that the transport bracket has been removed before using the washing machine.
G
Gwendolyn DixonAug 23, 2025
What to do if Hotpoint Ariston WMTF722HUK shows 'Clean pump'?
- R
  Rachel FranklinAug 23, 2025
  If your Hotpoint Ariston Washer displays the 'Clean pump' message, check the drain hose for any kinks. Inspect the filter or pump for blockages. Ensure that the water has cooled before draining the appliance. Also, verify that the drain hose is not frozen. After resolving the issue, select and start the 'Drain' program or push the 'Reset' button for at least 3 seconds, then restart the desired program. If the fault persists, contact After-Sales-Service.
Y
Yvonne WarrenAug 26, 2025
What to do if Hotpoint Ariston WMTF722HUK Washer shows 'Fod'?
- S
  Shirley GibsonAug 26, 2025
  If your Hotpoint Ariston Washer displays the 'Fod' error, which indicates overfoaming, start a 'Rinse & Spin' program. Afterward, restart your desired program, but use less detergent this time. If the issue continues, unplug the appliance, turn off the water tap, and contact After-Sales Service.
K
Kim SuarezAug 28, 2025
How to fix unbalance during spinning in Hotpoint Ariston WMTF722HUK Washer?
- M
  Mrs. Lisa Roach DVMAug 28, 2025
  To address unbalance during spinning in your Hotpoint Ariston Washer, avoid washing small laundry loads. When washing a large or heavy item, add other laundry items of different sizes to balance the load. If you only want to spin the wet laundry, add more items of different sizes, then select and start the 'Rinse & Spin' program.
S
sara19Aug 31, 2025
What to do if Hotpoint Ariston Washer shows 'FA'?
- J
  Joseph HarperAug 31, 2025
  If your Hotpoint Ariston Washer displays the 'FA' error, which indicates a 'Waterstop fault', switch off the appliance, pull out the mains plug, and turn off the water tap. Carefully tilt the appliance forward to allow any collected water to drain from the bottom. Then, plug in the appliance again and turn the water tap on. If water immediately flows into the appliance without the appliance being started, there is a failure; turn off the tap and notify After-Sales Service. Otherwise, select and start the desired program again.
M
mayalejandraSep 2, 2025
What to do if Hotpoint Ariston Washer shows 'F09'?
- A
  Angela SmithSep 2, 2025
  If your Hotpoint Ariston Washer displays the error code 'F09', which indicates a water level that is too high, switch off the appliance and then switch it back on. Select the 'Drain' program and start it within 15 seconds.
J
jennifer78Sep 5, 2025
Why is the Hotpoint Ariston WMTF722HUK programme duration longer than indicated?
- M
  Miguel JohnsonSep 5, 2025
  The programme duration of your Hotpoint Ariston Washer can vary due to factors like excessive foam formation, load unbalance, or low inlet water temperature. The washer adapts to these conditions, recalculating the duration as needed. For small loads, the program time may be reduced by up to 50%.
J
jordansarahSep 7, 2025
What to do if Hotpoint Ariston WMTF722HUK Washer detergent dispenser contains residues?
- W
  William GregorySep 7, 2025
  If your Hotpoint Ariston Washer's detergent dispenser contains residues after the wash, ensure the dispenser is properly installed and not blocked. Also, check if the filter in the water inlet hose is blocked.
J
Janice GibsonSep 9, 2025
Why does my Hotpoint Ariston Washer not start after pressing 'Start(Pause)'?
- J
  Jason StevensSep 9, 2025
  If your Hotpoint Ariston Washer doesn't start even after pressing 'Start(Pause)', make sure the lid is properly closed. Also, check if the 'Child lock' function is activated. If so, unlock the buttons by pushing the temperature and spin speed buttons simultaneously and holding them for at least 3 seconds, until the key symbol on the display disappears.

Summary

Safety and General Recommendations

Safety Instructions

General safety guidelines for appliance operation, including indoor use and child supervision.

Before Using the Washing Machine

Remove Packaging and Transport Bracket

Instructions for removing all packaging and the transport bracket to prevent damage.

Installation Requirements

Ensure stable, level placement, connect water supply and drain hose correctly, and check dimensions.

Electrical Connection

Guidance for safe electrical connection by a qualified technician, adhering to regulations.

Installation

Remove Transport Bracket

Steps to remove the transport bracket and secure outer screws before operation.

Machine Placement and Levelling

Water Supply Connection

Connect the water inlet hose securely to the valve and tap, checking for kinks and leaks.

Drain Hose Connection

Connect the drain hose to a siphon or outlet, ensuring correct height and no kinks.

Electrical Connection

Earthing Requirement

Mandatory earthing of the appliance for safety. Plug must have correct earth continuity.

Rewirable Plug Connection

Laundry Preparation

Loading the Laundry

Detergents and Additives

Detergent Selection and Dosage

Detergent Dispenser Use

Care and Maintenance

Cleaning Filter and Draining Water

Transport and Handling

Troubleshooting Guide

Appliance Start and Programme Issues

Vibration and Spin Performance

Failure Indicator Descriptions

Service Indicators

Explains 'Service' related error codes ('bdd', 'F02'-'F35', 'F09', 'FA', 'Fod') and their solutions.

Water Supply Issues

Pump and Drain Issues

Hotpoint Ariston WMTF722HUK Specifications

General

Load Capacity	7 kg
Spin Speed	1200 RPM
Energy Efficiency Class	A+++
Number of Programs	16
Width	60 cm
Depth	54 cm
Height	85 cm
Delay start	Yes
Quick wash	Yes
Color	White