THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance, please
register your product on www.whirlpool.eu/register
Policies, standard documentation, ordering of spare parts and additional product information can be
found by:
• Visiting our website docs.whirlpool.eu and parts-selfservice.whirlpool.com
• Using QR Code
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product’s identifi cation plate.
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance, please register
your product on:
www.whirlpool.com.hk / www.whirlpool.com.sg
You can download the user manual by:
• Visiting our website
www.whirlpool.com.hk/www.whirlpool.com.sg
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product’s identifi cation plate.
EN
Quick guide
Before using the appliance carefully read the Safety
Instruction.
Heat Pump System
The heat pump contains fluorinated greenhouse gases,
contained in a hermetically sealed unit. This sealed unit contains
0.43 kg of the F gas R134a. GWP = 1430 (1 t CO).
Power consumption
off-mode (Po) - Watts 0.33
left-on mode (Pl) - Watts 2.00
Programmes kg kWh Minutes
Eco Cotton *
9 1.64 210
Eco Cotton
4.5 0.86 120
Synthetics 4 0.50 78
*This is the reference programme for the energy label and suitable to
dry normal wet cotton laundry. This is the most efficient programme
in terms of energy consumption for drying wet cotton laundry.
(Standard/Default starting configuration)
TRANSPORT AND HANDLING
Never lift the dryer by holding on to its top side.
1. Unplug the dryer
2. Remove the water from the water tank completely.
3. Make sure that door and water tank are properly closed.
Cleaning the tumble dryer
• The external metal, plastic and rubber parts can be cleaned
with a damp cloth.
• Clean the front air intake grille regularly (every 6 months)
with a vacuum cleaner to remove any lint, fluff or dust
deposits. Furthermore, remove any lint deposits from the
filters area, using a vacuum cleaner every so often.
• Do not use solvents or abrasives.
Press the OK button to confirm.
This option remains in memory, if selected in previous drying.
Cycle Option
This button provides access to the menu of options below. Scroll
the options with the “UP” and “DOWN” buttons and press the
OK button to confirm the selection.
•
Gentle
Enables a more gentle treatment of the laundry by
reducing the drying temperature.
•
Iron Ready
This option signals when the garments reach a dryness
level suitable for ironing by means of the beeps and the display.
Remove the garments to be ironed, close the door and press
the Start/Pause button. The dryer goes on working until the
remaining garments reach the selected dryness level.
1
2
3
B
C
C
B
B
C
B
C
C
Step 1
Step 2
Step 3
Step 1
Step 2
Step 3
A
CARE AND MAINTENANCE
WARNING: unplug the dryer during the cleaning and
maintenance procedures.
Emptying the water tank after each cycle (see g. A).
Pull the container out of the dryer and empty it into a sink or
other suitable drain, then place it back properly. Do not use the
dryer without having inserted the container back in place.
Cleaning the primary door lter after each cycle (see g. B).
Pull the primary door filter out and clean it by removing the lint
from the filter surface under running water or using a vacuum
cleaner.
Cleaning the secondary door filter when the relevant
indicator turns on (see g. C).
Pull the secondary door filter out and clean it in all its parts by
washing it under running water or using a vacuum cleaner.
Clogged lters - clean both door lters (see g. B, g. C).
For optimal performance, dry the lters before inserting them
back in place.
Do not use the dryer without having inserted all lters back
in place properly rst.
The lters are essential parts for drying. They are intended
to collect the lint formed during the drying process. In case
of clogged lters, the air ow inside the dryer would be
seriously aected: the drying time would be longer, the
energy consumption would increase and the dryer could be
damaged. If these procedures are not carried out properly,
the dryer may not start.
Autoclean
The maintenance of the bottom filter of this model is
automatic. The dryer carries out cleaning when the sensors signal
the need to do so. In this case, the machine goes on working even
when the drying cycle is completed. An indicator on the control
panel will signal the maintenance. Do not switch the machine
o during this phase.
PRODUCT DESCRIPTION
1. Water Tank (A)
2. Air Intake grille
3. Door filter: primary (B), secondary (C)
To Next Page
Loading...
