Hotpoint HPS10L - Care and Cleaning

6 49-1000695 Rev. 1
Care And Cleaning
CLEANING THE OUTSIDE
Directions for Cleaning Outside Surfaces, Door Handles, and Trim
POWER INTERRUPTIONS
In the event of a power interruption, unplug your
refrigerator from the power source. Avoid opening
the doors until after power has been restored. Your
refrigerator will maintain a cold temperature for longer if
door opening is avoided or kept to a minimum.
Once power has been restored, plug your refrigerator
back into the power source and inspect food in the
refrigerator for spoilage or thawing. Cleaning your
refrigerator after a prolonged power outage is strongly
recommended to avoid odors and potential health
hazards due to thawing.
CLEANING THE INSIDE
Prepare a cleaning solution of 3-4 tablespoons of
baking soda mixed with warm water. Use a sponge
or soft cloth, dampened with the cleaning solution,
to wipe the inside of your refrigerator.
CAUTION
Do not clean glass shelves with warm
water when they are cold. Glass shelves may break if
exposed to sudden temperature changes or impact such as
bumping or dropping. Tempered glass is designed to shatter
into many small pieces if it breaks.
Do not wash any plastic freezer parts, glass or wire
shelves in dishwasher.
Do not use harsh chemicals, ammonia, chlorine bleach,
concentrated detergent, solvents, abrasives or metal
scouring pads to clean your refrigerator, inside or out.
They can damage and/or discolor the refrigerator finish.
LED LIGHTING REPLACEMENT
WARNING
Before cleaning your refrigerator, ALWAYS unplug it from the power source. Failure to heed this
warning could result in injury or death from electric shock.
DO USE DO NOT USE
Soft, clean cloth or sponge Abrasive cloths, scrubbing sponges, scouring or steel
wool pads
Mild detergent mixed with warm water
Approved stainless steel cleaners; Visit hotpoint.com for
approved stainless steel cleaners.
Cleaners with oxalic acid such as Bar Keepers Friend Soft
Cleanser™ can be used to remove surface rust, tarnish
and small blemishes on stainless steel surfaces only.
Abrasive powders or sprays
Window Sprays or Ammonia
Citrus or plant oil-based cleaners
Acidic or vinegar-based cleaners
Oven cleaners
Cleaners containing acetone (propanone)
Any cleaner with WARNING about plastic contact
WARNING
Do not change the LED light by yourself. Please contact the after-sales service for replacement. Failure to heed this
warning could result in injury or death from electric shock.
CARE AND CLEANING
NOTE: Before using any cleaning products, be sure to read the manufacturer’s instructions and warnings. This will
help avoid personal injury or damage to property.
NOTE: DO NOT allow stainless steel cleaner to come in contact with any plastic parts such as trim pieces, handle
hardware and liners. If unintentional contact of cleaners with plastic parts does occur, clean plastic part with a sponge
and mild detergent mixed with warm water.