8.914-364.0/97-6263 • Hotsy 9450/9460OF • Rev. 3/09
OPERATOR’S MANUAL
PRESSURE WASHER
8
OPERATION INSTRUCTIONS
STEP 1: Review installation instruc-
tions prior to connecting water sup-
ply and checking fuel tank and pump
oil level on both machines.
STEP 2: Connect high pressure
hose from pressure washer (not
included) to burner module.
STEP 3: Connect high pressure
hose from pressure washer when
connecting to burner module out-
let.
STEP 4: Attach high pressure wand
to spray gun of connected pressure
washer (Not Included).
STEP 5: Connect the power cords
into proper electrical outlet (See
Serial Port).
STEP 6: Turn on burner switch. Pilot
ignition will begin to spark. Confirm
pilot light ignition, if unsuccessful,
turn off switch and turn on again. If
pilot continues to spark, but not light,
consult troubleshooting guide.
To Next Page
Loading...