• If any or both tires are blocked, the Rally will stop after 2 seconds.
When the battery level has depleted below protection mode, the
Rally motor will power off after 15 seconds.
While sustaining a high discharge current during use (such as riding
up a steep slope for a long period of time), the Rally motor will power
off after 15 seconds.
CHARGING YOUR RALLY
CHARGING THE RALLY
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet.
• Connect the cable with the power supply (l OOV 240V; 50/60 Hz).
• Align and connect the I-pin charging cable into the charging port
of the Rally. DO NOT FORCE OR BEND THE CHARGING CABLE INTO
THE CHARGING PORT, AS IT MAY CAUSE THE PRONGS TO BEND OR
BREAK.
• The charging indicator light should change to RED, indicating that
your Rally is now being charged.
• When the RED indicator light on your charger turns to GREEN, then
your Rally is fully charged.
• A full charge may take up to 4 hours.
• After fully charging your Rally, unplug the charger from your Rally
and from the power outlet.
BATTERY CARE / MAINTENANCE
BATTERY SPECIFICATIONS
Battery Type: Rechargeable lithium-ion battery
Charge Time: Up to 4 hOl.Jrs
Voltage: 36V
Initial Capacity: 4.0 Ah
Working Temperature: 320F- 1040F
Charging Temperature: 320F - 1040F
Storage Time: I year
Storage Temperature: -40F - 77OF
Storage Humidity: -
BATTERY MAINTENANCE
The lithium-ion battery is built into the Rally. Do not disassemble the
Rally to remove the battery or attempt to separate it from the Rally.
16
To Next Page
Loading...
