Only use the enclosed charging
cable and charger to charge your
Rider. Using any other unauthorized
charger may damage your Rider.
CAUTION
9
• Make sure that there is no dust, debris or dirt inside the port.
• Locate the charge cable and plug the male end into a
grounded wall outlet.
• Plug the female end in the scooter’s charge port.
• The charging indicator light on your charger should change to
RED, indicating that your device is now being charged.
• When the RED indicator light on your charger turns to GREEN,
then your device is fully charged.
• A full charge may take up to 13 hours.
• After fully charging your scooter, unplug the charge cable from
the power outlet.
• Lift the charge port ap back up and push in to secure it back
into place.
To Next Page
Loading...
