HP 15-fb0 Series - Page 60

1. Remove the four Phillips M2.0 × 2.0 screws (1) that secure the touchpad bracket, and then remove the
bracket (2).
2. Remove the protective tape from the connector on the touchpad (1).
3. Disconnect the cable (2) from the touchpad ZIF connector.
4. Lift the keyboard cable that covers the touchpad screws (3).
5. Remove the Mylar that covers the screws (4).
6. Remove the grounding tape from the right screw (5).
7. Remove the three Phillips M2.0 × 2.5 screws (1) that secure the touchpad to the computer.
54
Chapter 6Removal and replacement procedures for authorized service provider parts