HP 15-fb0 Series - Touchpad

3. Lift the right edge of the system board, and then pull the board up and to the right to remove it from the
computer (2).
To install the system board, reverse this procedure.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 6-11 Touchpad description and part number
Description Spare part number
Touchpad, ceramic white N13309-001
Touchpad, mica silver N13310-001
Touchpad, performance blue N13311-001
Touchpad cable N13312-001
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 36).
2. Remove the bottom cover (see Bottom cover on page 36).
3. Remove the battery (see Battery on page 38).
4. Remove the fan assembly (see Fan assembly on page 45).
5. Remove the system board with the heat sink installed (see System board on page 50).
Remove the touchpad:
Touchpad
53