1. Prepare the computer for disassembly (see Preparation for disassembly on page 36).
2. Remove the bottom cover (see Bottom cover on page 36).
3. Remove the battery (see Battery on page 38).
4. Remove the fan assembly (see Fan assembly on page 45).
5. Remove the I/O board bracket (see I/O board on page 47).
6. Remove the system board with the heat sink installed (see System board on page 50).
7. Remove the plastic rear vent and n (see Plastic rear vent and n on page 55).
Remove the display assembly:
1. Open the display to open the hinges (1).
2. Remove the eight Phillips M2.6 × 4.5 screws (2) that secure the display assembly to the computer.
3. Separate the display from the computer (3).
4. If you need to remove the bezel:
a. Flex the top (1), the left and right sides (2), and then the bottom of the bezel (3) to release it.
b. Remove the bezel from the display (4).
The display bezel is available as spare part number N13327-001.
Display assembly 57
To Next Page
Loading...
