HP 1910 Series

2-550 m (multimode 62.5 µm core diameter, 500 MHz*km bandwidth)
2-550 m (multimode 50 µm core diameter, 400 MHz*km bandwidth)
2-550 m (multimode 50 µm core diameter, 500 MHz*km bandwidth)
2-10,000 m (single-mode fiber)
Notes A mode conditioning patch cord may be needed in some multimode fiber
installations.
Wavelength: 1310nm
Power Consumption: < 500mW Typical
Services Refer to the HP website at www.hp.com/networking/services for details on the
service-level descriptions and product numbers. For details about services and
response times in your area, please contact your local HP sales office.
HP X121 1G SFP RJ45 T
Transceiver (J8177C)
HP X121 1G SFP RJ45 T
Transceiver: An SFP format
gigabit transceiver with
RJ45 connectors using
1000BaseT technology.
Ports 1 RJ-45 1000BASE-T port (IEEE 802.3ab Type 1000BASE-T); Duplex: full only
Physical characteristics Dimensions: 2.71(d) x 0.54(w) x 0.55(h) in. (6.88 x 1.37 x 1.4 cm)
Weight: 0.06 lb. (0.03 kg)
Environment Operating temperature: 32°F to 158°F (0°C to 70°C); with 100 LFM airflow over
the SFP module
Operating relative humidity: 0% to 95% @ 75°F (25°C), noncondensing
Nonoperating/Storage temperature: -40°F to 185°F (-40°C to 85°C)
Nonoperating/Storage relative humidity: 0% to 95% @ 77°F (25°C),
noncondensing
Altitude: up to 10,000 ft. (3000 km)
Cabling Cable type:
1000BASE-T: Category 5 (5E or better recommended), 100 Ù differential 4-
pair unshielded twisted pair (UTP) or shielded twisted pair (STP) balanced,
complying with IEEE 802.3ab 1000BASE-T;
Maximum distance:
100 m
Notes Power consumption is nominally 1 watt.
For supported platforms and minimum software requirements to support this
product, see the document titled "Support for the J8177C 1000Base-T Mini-
GBIC" on the "HP Mini-GBICs and SFPs" Manuals Web page.
The J8177C Gigabit copper mini-GBIC is not supported on dual-personality
ports.
The J8177C is capable of 100 Mb operation. This is supported on only the HP
E8200zl, E5400zl, and HP E6200-24G-mGBIC yl Switches using software
version K.12.21 or later. Use the "auto-100" port setting to enable 100 Mb
operation.
Important: The earlier J8177B does not support 100 Mb operation. When used
in the Switch gl 20-Port 10/100/1000 Module (J4908A), the J8177C mini-GBIC
can be installed in either the upper or lower mini-GBIC
port, but will block access to the other port.
QuickSpecs
HP 1910 Switch Series
Accessory Product Details
DA - 13677 Worldwide — Version 12 — December 9, 2013 Page 32