Solid-state drive
Table 6-5 Spare part description and number
Description Spare part number
512 GB, PCIe, NVMe L49997-001
256 GB, PCIe, NVMe L49996-001
256 GB, SATA-3, TLC L49995-001
128 GB, SATA-3, TLC L49994-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 28).
2. Remove the optical drive (see Optical drive on page 29).
3. Remove the bottom cover (see Bottom cover on page 32).
4. Remove the battery (see Battery on page 34).
Remove the solid-state drive:
▲
Remove the Phillips M2.0 × 3.0 screw (1), and then pull the solid-state drive module from the socket (2).
Reverse this procedure to install the solid-state drive.
40 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
