9
Default Setting : Enabled
Recommended Setting : Enabled
i. Select Enabled.
This option enables / disables Serial Over LAN (SOL) functionality.
d. IDE Redirection
Default Setting : Enabled
Recommended Setting : Enabled
i. Select Enabled.
This option enables / disables IDE Redirection (IDE-R) functionality.
24) Skip Secure Firmware Update.
This option enables / disables the ability to remotely update the ME FW.
25) Skip Set PRTC.
26) Skip Idle Timeout.
Default Setting : 0
Recommended Setting : 0
27) Hit Esc to return to previous menu.
28) Hit Esc to Exit
a. Select Y.
This will exit the MEBx Setup and save settings.
29) The system will display the state of Intel AMT and an Intel ME Configuration Complete
message.
30) System will continue into the OS.
After the configuration is complete, it will go from In-Setup phase to Operational phase. AMT is fully
operational. Once in the Operational phase, the system can be remotely managed through the Intel
AMT WebGUI or ISV remote console and can be provided to the end-user for regular use.
Once an AMT system is configured, it will display its status and show that the AMT tables are valid on
every boot.
Intel AMT WebGUI
The Intel AMT WebGUI is a web browser based interface for limited remote system management.
The WebGUI is often used as a test to determine if AMT Setup and Configuration was performed
properly on a system. A successful remote connection between a remote system and the host system
running the WebGUI indicates proper AMT Setup and Configuration on the remote system.
The AMT WebGUI is accessible from the following web browsers:
• Microsoft Internet Explorer 6 SP1 or newer
• Netscape Navigator 7.1 or newer
• Mozilla Firefox 1.0 or newer
• Mozilla 1.7 or newer
To Next Page
Loading...
Need help?
General
