HP 255 G6 - Hard Drive and Connector Board Replacement

Rubber feet
Description Spare part number
Rubber feet, upper
Asteroid silver 931599-001
Dark ash silver 931600-001
Rubber feet, lower
Asteroid silver 931601-001
Dark ash silver 931602-001
Before removing the rubber feet, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
To remove the rubber feet:
▲
Peel the lower rubber feet (1) and upper rubber feet (2) from the bottom of the computer.
NOTE: The lower feet and upper feet are dierent sizes.
Reverse this procedure to install the rubber feet.
Component replacement procedures 37