To replace the DC controller, follow steps 1 through 6 above in reverse order.
Separation pad removal and replacement
Use the following procedure to remove the separation pad.
1 Remove Tray 2 (shown) or optional Tray 3.
2 Remove two (2) screws that attach the separation pad.
3 Remove the separation pad assembly (RC1–5356–000CN).
To replace the separation pad, follow steps 1 through 3 above in reverse order.
NOTE Align the tabs with the two (2) slots and then replace the separation pad.
88 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...