3 Turn on the printer.
4
When you see the message Permanent storage init displays, release the
(L
EFT
ARROW
) and
(R
IGHT
ARROW
) buttons.
When the super NVRAM init is complete, the printer will return to the Ready state.
Restoring page counts and serial number
A software utility is available on the Service and Support CD-ROM to restore page counts and serial
numbers when the formatter is replaced or when any of the following settings are lost:
■ Color page count
■ Total page count
■ Formatter number
■ Service ID
■ USB serial number
To access the utility on the Service and Support CD-ROM, in the Library folder, double-click the
2600config.exe program. You can run the utility from the CD-ROM or copy it to your computer.
NOTE To use this program, the printer must be directly connected to your computer with a
USB cable.
Cleaning the ETB
To clean the ETB, use the following procedure:
1 Enter the Secondary service menu. For more information, see
Secondary service menu.
2 Scroll through the menu and select C
LEAN
ETB.
3
Press the
(S
ELECT
) button to start the cleaning mode.
ENWW Service mode functions (SERVICE ONLY) 127
To Next Page
Loading...