HP 3000 Series Installation And Service Manual

IMMMI
CONFIGURING MPEI c I
This appendix briefly describes how tc configure the MPE
Opera.ting System tc include the HP 30010A Inte:lligent Network
Prcces sor (INF) •
CONFIGURATION OVERVIEW
rrt1e programs and intrinsics that comprise your data communica-
t.ions subsystems (such as DS/3000, RJE/3000, etc.) are supplied
as part of your MPE Operating System. Only the MPE I/O
configuration needs to be modified to include the Intelligent
1
tJetwork Processor (IHP) and any pseudo devices that may be re-
quiced for subsystem operation.
Before configuring MPE, install the INP as described in Section
II, Installation. The DRT number configured on the INP-MPU board
(step b of paragraph 2-5, "PCA Jumpers and Switches") should be
noted because it is requested during the configuration dialogue.
If the I/O configuration is compatible, the same INP can be used
for DS/3000, RJE/3000, MRJE/3000, or IML/3000 remote activities. I
Some information provided in the MPE configuration dialogue may
be relevant only when the INP is used with one particular sub-
system. Any configuration differences or special considerations
are noted in the following dialogue.
Besides configuring the INP and subsystem pseudo devices, you I
must, of course, configure any terminals and line printers that
are to be used for the Pass-Through Mode of operation. These are
standard MPE I/O configurations as described in the System
Manager / System Supervisor Reference Manual.
JUN 1980
C-1

HP 3000 Series Specifications

General

Brand	HP
Model	3000 Series
Category	Desktop
Language	English