Disabling network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
●
Decreases printer-generated network traffic
●
Prevents unauthorized users from printing to the printer
●
Provides only pertinent information on the configuration page
●
Allows the printer control panel to display protocol-specific error and warning messages
To disable IPX/SPX
NOTE Do not disable this protocol in Windows-based systems that print to the printer using
IPX/SPX.
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
4. Press
to highlight EMBEDDED JETDIRECT, and then press .
5. Press
to highlight IPX/SPX, and then press .
6. Press
to select ENABLE.
7. Press
to highlight OFF, and then press .
8. Press Menu to return to the Ready state.
To disable AppleTalk
1. Press Menu.
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
4. Press
to highlight EMBEDDED JETDIRECT, and then press .
5. Press
to highlight APPLETALK, and then press .
6. Press
to select ENABLE.
7. Press
to highlight OFF, and then press .
8. Press Menu to return to the Ready state.
To disable DLC/LLC
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
ENWW Network configuration 47
To Next Page
Loading...