4. Slide the width guides slightly wider than the print media.
5. Place print media into the tray with the side to be printed down, and the top, short edge in first.
NOTE If you are printing on two sides, see
Using 2-sided (duplex) printing for loading
instructions.
6. Slide the paper width guides inward until they lightly touch the print media stack on both sides without
bending it. Make sure that the media fits under the tabs on the width guides.
CAUTION Wait for the printer to finish printing before closing tray 1 (optional). Closing the
tray before the printer finishes can cause jams.
58 Chapter 4 Printing tasks ENWW
To Next Page
Loading...