EasyManuals Logo

HP 300X - JetDirect Print Server User Manual

HP 300X - JetDirect Print Server
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
76 HP Jetdirect Configuration Page Messages ENWW
PSERVER CLOSED
CONNECTION
The print server requested a termination of the connection
with the HP
Jetdirect print server. No error exists or is
indicated. Make sure the print server is running, and
restart it if necessary.
READY The HP Jetdirect print server has successfully connected
to the server and is awaiting data.
RECEIVE BUFFER
ERROR
Run the power-on self-test: turn the print server off,
then
on again. If the error persists, replace the
HP
Jetdirect print server.
RETRY ERROR Check the Ethernet cable. Make sure your HP Jetdirect
print server is correctly attached to your network.
SQE ERROR Run the power-on self-test: turn the print server off,
then
on again. If the error persists, replace the
HP
Jetdirect print server.
TFTP IN PROGRESS The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
TFTP and has not detected any errors.
TFTP LOCAL ERROR The TFTP transfer of the configuration file from the host
to the HP
Jetdirect print server failed with the local print
server encountering some form of inactivity timeout, or
excessive retransmissions situation.
TFTP REMOTE ERROR The TFTP transfer of the configuration file from the host
to the HP
Jetdirect print server failed with the remote host
sending a TFTP ERROR packet to the print server.
TFTP RETRIES
EXCEEDED
The overall retrying of the TFTP transfer of the
configuration file from the host to the HP
Jetdirect print
server has exceeded a retry limit.
TRANSMIT ERROR Check the network topology and verify all cable segments.
TRYING TO CONNECT
TO SERVER
The HP Jetdirect print server is trying to connect to the
print server or NetWare file server after being configured.
Wait for the print server to establish a connection with the
print or file server.
TURN PRINTER OFF/ON This message may appear after you upgrade to a new
version of firmware. When this message appears, turn the
print server off, then back on to enable any new
functionality that was recently downloaded.
Table 7.2 General HP Jetdirect Messages (8 of 10)
Message Description

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 300X - JetDirect Print Server and is the answer not in the manual?

HP 300X - JetDirect Print Server Specifications

General IconGeneral
BrandHP
Model300X - JetDirect Print Server
CategoryPrint Server
LanguageEnglish

Related product manuals