Changing the number of copies
You can choose to have the default number of copies be any number from 1 to 99.
To change the number of copies for the current job
1. On the device control panel, press #
OF
COPIES
and use the < or the > button to increase or
decrease the quantity that appears on the device control panel display.
OR
Use the alphanumeric buttons to type the number of copies (between 1 and 99) that you
want to make for your current job.
2. Press
START
/
COPY
to begin copying your job.
Note
The change in the setting remains active for about two minutes after the copy job has been
completed. During this time, Settings=Custom appears on the device control panel display.
To change the default number of copies
1. On the device control panel, press
MENU
/
ENTER
.
2. Use the < or the > button to select Copy setup, and then press
MENU
/
ENTER
.
3. Use the < or the > button to select Def. # of copies, and then press
MENU
/
ENTER
.
4. Use the alphanumeric buttons to type the number of copies (between 1 and 99) that you
want as the default.
5. Press
MENU
/
ENTER
to save your selection.
Note
The factory-set default for the number of copies is 1.
ENWW Changing the number of copies 57
To Next Page
Loading...