EN
Document scanner assemblies
95
Document scanner assemblies
Printer door
1
Press the printer door release latches and open the printer door.
2
Remove all covers and the RFI shield.
3
Pull the four (4) cables (callout 1) from the connectors aligned
vertically along the right side of the formatter board, and then
open tie-wrap that holds all four cables to release the cables.
4
Remove the three (3) grounding screws (callout 2).
Figure 23. Printer door removal (1 of 3)
Note
Upon reinstallation, make sure that you reinstall the grounding wires to
their correct locations.
To Next Page
Loading...