Installing an adapter 10
1.
Using a correctly sized slotted screwdriver, carefully remove the two board lock screws located at the
top and bottom of the connector.
2. Remove the standard profile bracket and place the low profile bracket over the connector. Be careful
not to damage the connector or bind the low profile bracket to the connector.
Connecting the network cable
To secure the cable, plug the cable connector into the RJ-45 port. Ensure that the tab on the plug clicks into
position indicating that it is properly seated.
For more information, see UTP cable specifications (on page 11).
To Next Page
Loading...
Need help?
General
