Scanner installation 3
Scanner installation
Install the software BEFORE the hardware
1 Close all applications (except Windows).
2 Insert the HPCD-ROM into your CD-ROM drive. The Installer
starts.
Note If the Installer does not start, select Start > Run and type D:\setup.exe
where D is the letter of your CD-ROM drive.
3 Follow the instructions on your PC screen.
4 For more information, click Registration and Additional Help.
Installing the scanner
Installing the HP ScanJet scanner is quick and easy. In just a short
time, you can scan and copy documents. The steps required to install
the scanner are listed below.
1 Unlock the scanner by sliding the plastic lock on the bottom of the
scanner up to the unlocked position.
2 Choose the cable you will use to connect your scanner.
• Two cables have been included with your scanner: a USB
cable and a Parallel cable. You will use only ONE of these
cables.
• For best performance, connect the USB cable unless:
• You are running Windows 95.
• Your computer does NOT have a USB port.
• You chose parallel during scanning software installation.
WARNING! Only use the power supply, cables, and accessories supplied with this
equipment or expressly approved by Hewlett-Packard Company.
DTMiniManual.fm Page 3 Monday, May 15, 2000 1:31 PM
To Next Page
Loading...