4 Front panel
3 Connect your scanner.
• USB
a Connect the USB cable to the USB port on the back of the
scanner, then to one of the USB ports on your PC.
b Do not connect the parallel cable.
• Parallel:
a Make sure your PC is off. If you do NOT have a printer, go
to step d.
b Disconnect the printer's parallel cable from the PC.
c Connect the printer cable to the scanner's parallel port.
d Use the parallel cable that came with the scanner to
connect the scanner to your PC.
e Do not connect the USB cable.
4 Connect the power supply to the scanner and plug the power
cord into an electrical outlet.This turns on power to the scanner.
Note If you installed Parallel, you must now restart your PC.
The scanner does NOT have an on/off switch.
Congratulations! Your scanner is now installed.
Front panel
Use the Scanner Buttons
Place a document on the scanner glass, and then press one of the
following scanner buttons:
l SCAN: Starts the HP scanning software.
l E-MAIL: Scans and attaches your document to a new e-mail
message from your installed e-mail software.
l COPY PANEL: Scans and prints copies of your document.
DTMiniManual.fm Page 4 Monday, May 15, 2000 1:31 PM
To Next Page
Loading...