1 RJ-45 out-of-band management port
1 stacking module slot
Power supplies
2 power supply slots
1 minimum power supply required
includes: 1 x J9580A (HP X312 1000W 100-240VAC to 54VDC Power Supply)
Fan tray
includes: 1 x J9582A
1 fan tray slot
Physical characteristics
Dimensions
17.43(w) x 18.4(d) x 1.7(h) in (44.27 x 46.74 x 4.32 cm) (1U height)
Weight
17.24 lb (7.82 kg) switch chassis with 1 power supply and fan tray installed
Memory and processor
Processor
HP ProVision ASIC/ARM @ 350 MHz; Freescale P2020 @ 1200 MHz, 4 GB flash,
2 GB SDRAM; packet buffer size: 36 MB dynamic
Mounting
Mounts in an EIA-standard 19 in. telco rack or equipment cabinet (hardware included); horizontal surface
mounting only
Performance
1000 Mb Latency
< 2.8 µs (LIFO 64-byte packets)
10 Gbps Latency
< 1.9 µs (LIFO 64-byte packets)
Throughput
up to 130.9 million pps (64-byte packets)
Switching capacity
176 Gbps
Routing table size
10000 entries (IPv4)
MAC address table size
65500 entries
Environment
Operating temperature
32°F to 131°F (0°C to 55°C); max temperature is 45C when SFP+ transceivers
are installed
Operating relative
humidity
15% to 95% @ 104°F (40°C), noncondensing
Nonoperating/Storage
temperature
-40°F to 158°F (-40°C to 70°C)
Nonoperating/Storage
relative humidity
15% to 90% @ 149°F (65°C), noncondensing
Altitude
up to 10,000 ft (3 km)
Acoustic
Power: 57 dB, Pressure: 41.5 dB
Electrical characteristics
Maximum heat
dissipation
635 BTU/hr (669.93 kJ/hr)
Voltage
100-120/200-240 VAC
Current
9.4/7.8 A
Idle power
100 W
Maximum power rating
186 W
PoE power
1080 W
Frequency
50/60 Hz
Notes
Idle power is the actual power consumption of the device with no ports
connected.
Maximum power rating and maximum heat dissipation are the worst-case
theoretical maximum numbers provided for planning the infrastructure with
fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all
modules populated.
QuickSpecs
HP 3800 Switch Series
Technical Specifications
DA - 14152 Worldwide — Version 15 — January 16, 2014
Page 44