Model 4145A
Table l-3. Accessories Supplied (Sheet 4 of 5)
SECTION I
Configuration
Description
Three-meter triaxial (m) Cable
(04145-61622):
Triaxial (m) cable for connection between
the 4145A’s SMU terminals and the
Connector Plate. Cable length is 3m.
Four cables are furnished.
Refer to
Figure 3-35 for the usage.
Three-meter BNC (m) Cable
(04145-61630):
BNC (m) cable for connection between
the 4145A’s Vs or Vm terminals and the
Connector Plate. Cable length is 3m.
Four cables are furnished. Refer to
Figure 3-35 for the usage.
Shorting Connector (04145-61623) :
Allows SMU output voltage to exceed
+42V when the 16058A Test Fixture is not
used. With the Shorting Connector
connected to the System Cable connector
on the rear panel, the instrument’s _
fixture-lid-open detector is disabled, and
the instrument
assumes a fixture-
lid-closed condition.
WARNING
A POTENTIAL SHOCK HAZARD
EXISTS WHEN THE SHORTING
CONNECTOR IS CONNECTED
TO THE 4145A. DO NOT TOUCH
THE OUTPUT TERMINAL OR
INNER CONDUCTOR OF SMU
DURING MEASUREMENT.
To Next Page
Loading...
