SECTION III
Model 4145A
3-5. FLEXIBLE DISC HANDLING
CAUTION
DO NOT INSERT ANYTHING OTHER
THAN FLEXIBLE DISCS INTO THE
DISC DRIVE.
3-6. Five work-discs and one head-cleaning
disc are furnished with the 4145A. Each
work-disc contains the required operating system
software, four general purpose measurement
setups, and 33.5K bytes of user area.
Installation and removal procedures for the disc
are shown in Figure 3-4. Precautions on handling
and storing the flexible discs are given below.
1. When not in use, each disc should be placed
in its own outer jacket. Exposed areas of
the disc should be completely covered by
the jacket.
2.
Store discs in an upright position. Do not
stack or pile discs.
3. Store discs in a clean, dry, fireproof
cabinet. Do not expose to direct sunlight,
extremes of temperature or humidity, or
Note
Use only the discs furnished with the
4145A.
3-7.
CRT DISPLAY
3-8. The 4145A is equipped with the HP Model
1345A Digital Display.
For complete infor-
mation on the 1345A, refer to the 1345A
Operation and Service Manual, included in this
binder.
3-9. Useable display area on the CRT is shown
in Figure 3-5. Operator adjustments are given in
magnetic fields.
Figure 3-6.
4. Do not touch the exposed surface of the disc.
5. Do not apply strong pressure to the
protective jacket. When labelling a disc,
use a felt-tip pen. Do not use a pencil or
ball-point pen.
-‘.
6.
Do not bend the discs.
(a) Push firmly and (b) Door opens.
(c) Carefully
release. insert or
remove the
disc.
(d) Push the door
until clicks.
Note:
Fully
insert the disc into the disc drive before closing the disc drive door.
Figure 3-4. Disc Installation and Removal.
3-10
To Next Page
Loading...
