HP 4278A - Page 111

VMON SOFTKEY LABEL: MONITR OFF/OPEN/SHORT/STD/STD REF/OFFSET/
LIMIT NOM (in 'VALUE MONITR')
The VMON command selects the monitor display on the monitor line.
SYNTAX:
Control
Parameter
Description
1 Set the monitor display to OFF.
2
Set the monitor display to OPEN data.
3
Set the monitor display to SHORT data.
4
Set the monitor display to STD meas data.
5
Set the monitor display to STD ref data.
6 Set the monitor display to offset data.
7
Set the monitor display to nominal value.
VMON
PARAMETER:
control
The control parameter choices are:
The default setting is VMON1.
EXAMPLE:
OUTPUT 717;"VMON21 Set the monitor display to OPEN data
4-46