HP 4284A - Page 284

INITiate Subsystem
INITiate Subsystem
The INITiate subsystem command group controls initiation of
the triggering system. Figure 8-9 shows the command tree of the
INITiate subsystem command group.
Figure 8-9. INITiate Subsystem Command Tree
[:IMMediate]
The [:IMMediate] command changes the trigger state to the IDLE
STATE to the WAIT FOR TRIGGER STATE for one trigger
sequence. For details, refer to \Trigger System" in Chapter 7.
Command Syntax
INITiate
2
IMMediate
3
Example
OUTPUT 717;"INIT"
OUTPUT 717;"INIT:IMM"
Command Reference 8-43