HP 4284A - Page 303

COrrection Subsystem
:SPOT < n > :LOAD
:STANdard
The :SPOT < n > :LOAD:STANdard command sets the reference values
of the standard at the sp ecied frequency point (FREQ1, FREQ2
or FREQ3). The :SPOT < n > :LOAD:STANdard? query returns the
current settings of the reference values for FREQ1, FREQ2 or
FREQ3.
Command Syntax
CORRection:SPOT < n > :LOAD:STANdard < REF.A > , < REF.B >
Where,
< n > 1 Setting for FREQ1 p oint
2 Setting for FREQ2 p oint
3 Setting for FREQ3 p oint
< REF.A > is the NR1, NR2, or NR3 format :
Primary parameter's reference value of the standard
< REF.B > is the NR1, NR2, or NR3 format :
Secondary parameter's reference value of the
standard
Example
OUTPUT 717;"CORR:SPOT1:LOAD:STAN 100.7,0.0002"
Query Syntax
CORRection:SPOT < n > :LOAD:STANdard?
Query Response
Returned format is :
<NR3>,<NR3><NL^END>
Example
10 OUTPUT 717;"CORR:SPOT1:LOAD:STAN?"
20 ENTER 717;A,B
30 PRINT A,B
40 END
8-62 Command Reference