HP 4284A - Page 310

COMParator Subsystem
:TOLerance:BIN < n >
The :TOLerance:BIN < n > command sets the low/high limit values of
each BIN for the comparator function tolerance mo de. These limits
can b e set only when the limit mo de is set to the tolerance mo de.
The :TOLerance:BIN < n > query returns the current settings of the
low/high limit values of each of the BINs.
Command Syntax
COMParator:TOLerance:BIN < n >< low limit > , < high limit >
Where,
< n > 1 to 9 (NR1) : BIN number
< low limit > NR1, NR2, or NR3 format : low limit value
< high limit > NR1, NR2, or NR3 format : high limit value
Note
The low limit value should b e lower than the high limit value. If the
low limit value is set higher than the high limit, a warning message is
displayed when this command is received (an error do es not o ccur).
Example
OUTPUT 717;"COMP:TOL:BIN1 -5,5"
OUTPUT 717;"COMP:TOL:BIN2 -10,10"
Query Syntax
COMParator:TOLerance:BIN < n > ?
Query Resopnse
Returned Format is :
< low limit > , < high limit > <NL^END>
Example
10 OUTPUT 717;"COMP:TOL:BIN1?"
20 ENTER 717;A,B
30 PRINT A,B
40 END
Command Reference 8-69