HP 4284A - Page 351

Other Functions
Store/Load
Ten instrument control settings, including comparator limits and list
sweep programs, can b e stored and loaded from and into the internal
non-volatile memory.Ten additional settings can also b e stored and
loaded from each removable Memory Card.
HP-IB
All control settings, measured values, comparator limits, list
sweep program. ASCI I and 64-bit binary data format. HP-IB
buer memory can store measured values for a maximum of 128
measurements and output packed data over the HP-IB bus. Complies
with IEEE-488.1 and 488.2. The programming language is SCPI.
Interface Functions. SH1, AH1, T5, L4, SR1, RL1, DC1, DT1, C0, E1
Self Test
Softkey controllable. Provides a means to conrm prop er op eration.
Options
Option 001 (Power Amp/DC Bias)
Increases test signal level and adds the variable dc bias voltage
function.
Test Signal Level
Mode Range Setting Accuracy
Voltage Non-constant
Constant
1
5mVto20Vrms
10 mV to 10 Vrms
6 (10%+1 mV)
6 (10%+1 mV)
Current Non-constant
Constant
1
50  A to 200 mArms
100  A to 100 mArms
6 (10%+10  A)
6 (10%+10  A)
1 Automatic Level Control Function is set to ON.
Output Impedance
100 , 6 6%
9-18 General Information