HP 4284A - Page 38

To remove the fuse, turn the fuse holder counterclockwise until the
fuse p ops out.
Caution
Use the prop er fuse for the line voltage selected. Use only fuses with
the required current rating and of the specied type as replacements.
DO NOT use a mended fuse or short-circuit the fuse-holder in order
to by-pass a blown fuse. Find out what caused the fuse to blow!
Operation
Environment
The HP 4284A must b e op erated under within the following
environment conditions, and sucient space must b e kept b ehind the
HP 4284A to avoid obstructing the air ow of the co oling fans.
Temperature: 0

Cto55

C
Humidity: less than 95% RH at 40

C
Note
The HP 4284A must b e protected from temperature extremes whic
h
could cause condensation within the instrument.
Electromagnetic
Compatibility
This pro duct has b een designed and tested to the requiremen
ts of
the Electromagnetic Compatibility (EMC) Directive 89/336/EEC.
To use a prop erly shielded cable or shielded coaxial cable (suc
has
those recommended in the General Information and the P
erformance
Test) to connect each of the p orts to their respectiv
e controllers,
peripherals, equipments or devices may ensure to meet the
requirements.
Installation and Set Up Guide 1-5