Error
No.
Displayed Message
Description
!
Solution
61 Clear the table rst
Illegal op eration, the sweep parameter of the LIST SWEEP
SETUP is changed when the sweep list for other parameter
exists.
!
Clear the existing list rst.
62 Bias o, Turn bias on
Illegal op eration, DC bias sweep was attempted while the
DC BIAS is OFF.
!
Press
4
DC BIAS
5
to set DC bias to on.
70 Handler I/F not installed
Illegal op eration, HANDLER I/F set to ON when Option
201 or 202 was not installed.
!
Install Option 201 or 202.
Illegal op eration, HANDLER I/F test was p erformed when
Option 201 or 202 were not installed.
!
Install Option 201 or 202.
71 Scanner I/F not installed
Illegal op eration, SCANNER I/F set to ON when Option
301 was not installed.
!
Install Option 301.
Illegal op eration, Scanner I/F EEPROM R/W test or
Scanner I/F I/O test were performed when Option 301 was
not installed.
!
Install Option 301.
72 HP-IB I/F not installed
Illegal op eration, HP-IB interface used when Option 109
was installed.
!
Install the HP-IB interface.
73 I BIAS I/F not installed
Illegal op eration, BIAS Current I/F I/O test p erformed
when Option 002 is not installed.
!
Install the Option 002 Bias Currentinterface.
74 Illegal test setup
Illegal op eration, ACCESSORY CONTROL I/F test
performed when the HP 4284A and the HP 42841A are
connected with the accessory control interface cable.
!
Disconnect the interface cable from the HP 42841A.
80 Setup data protected
Setup data write protected by DIP switch A7SW3. (Refer
to Appendix E.)
!
Set bit 5 of DIP switch A7SW3 to the OFF p osition.
B-6 Error and Warning Messages
To Next Page
