HP 4395A - Page 302

Error Messages in Alphabetical Order
0 151 Invalid string data
A string data element was expected, but was invalid for some reason (see IEEE 488.2, 7.7.5.2).
For example,an END message was received before the terminal quote character.
0 131 Invalid sux
The sux does not follow the syntax described in IEEE 488.2, 7.7.3.2, or the sux is
inappropriate for the analyzer.
L
115 LIF-DOS COPY NOT ALLOWED
If you try to copy a le between the memory disk and the exible disk when the format of the
memory disk is dierent from the format of the exible disk, this message is displayed.
124 LIST TABLE EMPTY OR INSUFFICIENT TABLE
The frequency list is empty.To implement the list frequency mode, add segments to the list
table.
M
0 250 Mass storage error
Indicates that a mass storage error occurred. This error message is used when the analyzer
cannot detect the more specic errors described for errors
0 257.
0 311 Memory error
An error was detected in the analyzer's memory.
0 109 Missing parameter
Fewer parameters were received than required for the header
.For example, the *SRE
command requires one parameter, so receiving only *SRE is not allowed.
N
98 NO ACTIVE MARKER
The marker ! command cannot be execute when no marker is displayed on the screen. Turn
on the marker before executing the marker ! commands.
12 NO CALIBRATION CURRENTLY IN PROGRESS
The
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
RESUME CAL SEQUENCE softkey is not valid unless a calibration is in progress. Start a new
calibration.
268 NO COMPENSATION CURRENTLY IN PROGRESS
No compensation is currently in progress.
Messages-8