HP 54600 Series - User Manual

Check the instrument for damage and verify accessory contents.

Guide to connecting signals for basic operation and probe compensation.

Adjust vertical controls and observe status line changes for setup.

Configure trigger level, source, and mode for stable signal display.

Magnify and expand portions of the main sweep for detailed analysis.

Use peak detect and Autostore for capturing rapid waveform changes.

Utilize automatic measurement functions for frequency analysis.

Employ cursors for custom voltage or time measurements on signals.

Basic procedures for analyzing video signals using TV triggering.

Introduction to enhanced TV/Video triggering features for video analysis.

Triggering on a particular line within a video signal for detailed examination.

Precise video waveform analysis using integrated TV trigger features.

Performing frequency domain analysis using FFT on video signals.

Procedures to verify electrical performance against standards.

Procedures for hardware adjustments to maintain optimum performance.

Isolating and resolving operational problems to specific assemblies or components.

Instructions for removing, ordering, and replacing internal parts.

Specifications for vertical display, channels, bandwidth, and accuracy.

Specifications for sweep speeds, accuracy, resolution, and delay.

Specifications for trigger sensitivity, modes, coupling, and sources.

Specifications for sample rate, resolution, record length, and update rate.

Definitions of general oscilloscope operational and functional terms.

Definitions of terms specific to TV/video triggering features.

Compliance standards for safety and electromagnetic compatibility.

Critical safety precautions and warnings for instrument operation.