Need help?Do you have a question about the HP 54540 Series and is the answer not in the manual?
General| Brand | HP |
|---|---|
| Model | 54540 Series |
| Category | Test Equipment |
| Language | English |
Describes the oscilloscope's rear panel layout including power input and connectors.
Explains how to connect HP-IB compatible devices like printers and plotters for data transfer.
Explains the controls located at the top of the oscilloscope, including Autoscale and Run keys.
Identifies trigger points by slope and voltage level on a single source.
Sets measurement points (thresholds) using standard IEEE or user-defined settings.
Allows preset test parameters and storage of failure data for evaluation.
Selects operations, sources, and displayed results for waveform math and FFT functions.
Provides control keys to define the FFT function, including peak search and windowing.
Offers guidance for optimum measurements in the frequency spectrum.
Configures handshake settings and provides RS232 connector pin out information.
Describes the process for making automatic measurements like rise time and Vp-p.
Defines transition points through threshold levels to identify rising and falling edges.
Provides guidance on correctly windowing the display for accurate measurements.
To Next Page
