HP 54540 Series - Limit Test Menu

Figure 8-3
Define Measure Menu
Limit Test Menu
Limit Test Menu
The oscilloscope can min limit tests on up to three measurements
simultaneously. Using this menu, you can preset the test parameters and
store any failure data for evaluation at a later time. You start the limit test in
this menu, and you select the measurement from the front panel.
When a test is running, statistical data describing the test is displayed. You
must have at least one measurement selected before limit test can run.
DEFINE MEAS
measure define
- Tail if —,
|
S e| Sor ot <<: ———
1 ,.00C
~ on fail,save
~ after fail —~
(ERED continue
papa2nae
8-10