HP 54540 Series - Page 138

Define Measure Menu
Limit Test Menu
Test Softkey
The test softkey toggles the limit test on or off. When limit test is turned
on, the oscilloscope starts running in the test mode on the most current
measurements that are running.
Set Softkey
The set softkey allows you to select a measurement so that you can set up
the fail criteria for that test. The set softkey allows you to scroll through all
of the measurements; these are the same measurements as are available on
the keypad. The set softkey does not select the measurements on which the
limit test operates, that selection is made from the keypad.
Fail if Softkey
The fail if softkey sets the upper failure threshold. The upper range is
dependent upon the units of the selected measurement.
or if Softkey
The or if softkey sets the lower failure threshold. The lower range is
dependent upon the units of the selected measurement.
8-11