HP 4395A - Page 306

Error Messages in Alphabetical Order
0 420 Query UNTERMINATED
A condition causing an unterminated query error occurred (see IEEE 488.2, 6.3.2.2). For
example, the analyzer was addressed to talk and an incomplete program message was received
by the controller.
0 350 Queue overow
A specic code entered into the queue in lieu of the code that caused the error. This code
indicates that there is no room in the queue and an error occurred but was not recorded.
R
111 RECALL ERROR: INSTR STATE PRESET
A serious error, for example corrupted data, is detected on recalling a le, and this forced the
analyzer to be PRESET.
S
110 SAVE ERROR
A serious error, for example physically damaged disk surface, is detected on saving a le.
76 SEGMENT START/STOP OVERLAPPED
Segments are not allowed to be overlapped. Reenter appropriate value for start or stop value
of segments to avoid that segment is not overlapped.
0 330 Self-test failed
A self-test failed. Contact your nearest Hewlett-Packard oce or see the Service Manual for
troubleshooting.
0 221 Settings conict
A legal program data element was parsed but could not be executed due to the current device
state (see IEEE 488.2, 6.4.5.3 and 11.5.1.1.5).
128 SPAN = 0 ONLY
The setup must be zero span and spectrum analyzer mode when turning on the RF OUTPUT
.
0 150 String data error
This error, as well as errors 0 151 and 0 158, are generated when analyzing the syntax of a
string data element. This particular error message is used if the analyzer cannot detect a more
specic error.
0 158 String data not allowed
A string data element was encountered but was not allowed by the analyzer at this point in
parsing.
Messages-12