HP 4395A - Performance Tests; Introduction; Test Procedure Components

2
Performance Tests
INTRODUCTION
This chapter contains the performance test procedures. The test procedures listed in Table 1-1
are described sequentially in the following pages.
The test name indicates the tested performance and to which performance group the tested
performance belongs to. NA indicates the performance test belongs to the network analyzer
mode performance group. SA indicates the performance test belongs to the spectrum analyzer
mode performance group.
Each procedure consists of the following parts:
Description: describes the test procedure.
Specication: describes the performance veried in the test.
Test Equipment: describes test equipment required in the test.
Procedure: describes the test procedure step by step.
Note
Allow the analyzer to warm up for at least 30 minutes before you execute any
of the performance tests.
Perform all performance tests in an ambient temperature of 23
6 5

C.
Note
Before performing any tests, make extra copies of the calculation sheet in
Chapter 3 and the performance test record in Chapter 4. These are required
in the test procedure.For an explanation of how to use these records
, see the
CALCULATION SHEET AND PERFORMANCE TEST RECORD in Chapter 1.
Performance Tests 2-1