Labels
CAUTION To avoid damaging the printer, use only labels that are recommended for use in
HP Color LaserJet printers. Never print on the same sheet of labels more than once or print
on a partial sheet of labels.
Label construction
When selecting labels, consider the quality of each component:
●
Adhesives: The adhesive material should be stable at 200°C (392°F), the printer's fusing
temperature.
●
Arrangement: Only use labels that have no exposed backing between them. Labels can peel
off sheets that have spaces between the labels, causing serious jams.
●
Curl: Prior to printing, labels must lie flat with no more than 13 mm (0.5 inches) of curl in any
direction.
●
Condition: Do not use sheets of labels that have wrinkles, bubbles, or other indications of
separation.
NOTE Select labels in the printer driver.
Transparencies
Transparencies used in the printer must be able to withstand 200°C (392°F), the printer's fusing
temperature.
CAUTION To avoid damaging the printer, use only transparencies recommended for use in
HP Color LaserJet printers, such as HP-brand transparencies.
NOTE Select transparencies in the printer driver.
24 Chapter 1 Product information ENWW
To Next Page
Loading...