HP 48SX - Page 20

Transferring Data Between a Personal Computer and the HP 48. Before beginning the transfer,
m Connect computer and HP 48 via serial cable.
m
Using
the
I/O
SETUP
menu
((\)(I/0]
SETUF),
set
wire
transmission
mode,
ASCII
or
binary,
transfer
rate,
parity,
and
checksum.
= Go to the sending or receiving HP 48 directory.
m Press [()(i70) OFEHNT to open HP 48 serial port. (After transmission is complete, press [€](I/0] CLOZE to conserve
battery power.)