HP 48SX - Page 22

IOPAR Parameters {baud parity receive-pacing transmit-pacing checksum translate-code}
Parameter Description Parameter Description
baud Select 1200, 2400, 4800, or 9600. Default is transmit- Not used by Kermit protocol. Non-zero
9600. pacing value stops HP 48 transmission if XOFF
signal is received. Default is 0.
parity Select odd, even, mark, space, or no checksum Select the 1, 2, or 3 error detection option.
parity. Default is 0 (no parity). Default is 3.
receive- Not used by Kermit protocol. Non-zero translate- Select translate code of 0, 1, 2, or 3.
pacing value sends XOFF signal if HP 48 bufferis code Default is 1.
full. Default is 0.