3. Lift the front edge of the cover (2) and swing it toward you.
4. Remove the memory/Mini PCI card module compartment cover.
NOTE The memory/Mini PCI card module compartment cover is included in the Plastics/
Hardware Kit, spare part number 441630-001 .
5. Spread the retaining tabs (1) on each side of the memory module socket to release the memory
module. (The edge of the module opposite the socket rises away from the computer.)
6. Remove the memory module (2) by pulling the module away from the socket at an angle.
NOTE Memory modules are designed with a notch (3) to prevent incorrect installation into
the memory module socket.
Reverse this procedure to install a memory module.
ENWW Component replacement procedures 33
To Next Page
Loading...
