Base enclosure
Description Spare part number
Base enclosure 441625-001
Before removing the base enclosure, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
Battery on page 29).
5. Remove the following components:
a. Hard drive (see
Hard drive on page 30)
b. Memory/Mini PCI card module compartment cover (see
Memory module on page 32)
c. Optical drive (see
Optical drive on page 36)
d. Switch cover (see
Switch cover on page 38)
e. Keyboard (see
Keyboard on page 40)
f. Display assembly (see
Display assembly on page 44)
Remove the base enclosure:
1. Release the ZIF connector (1) to which the TouchPad cable is attached and disconnect the
TouchPad cable (2) from the system board.
2. Turn the computer upside down, with the front toward you.
ENWW Component replacement procedures 49
To Next Page
Loading...
