Display assembly
Description Spare part number
15.4-inch, WXGA BrightView display assembly for use only with computer models
with wireless LAN capability (includes wireless antenna transceivers and cables)
440716-001
15.4-inch, WXGA BrightView display assembly for use only with computer models
without wireless LAN capability
440715-001
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
Battery on page 29).
5. Remove the memory/Mini PCI card module compartment cover (see
Memory module
on page 32) and disconnect the wireless antenna cables from the Mini PCI card module (see Mini
PCI card module on page 34).
6. Remove the following components:
a. Switch cover (see
Switch cover on page 38)
b. Keyboard (see
Keyboard on page 40)
Remove the display assembly:
1. Close the computer and turn it upside down with the rear panel toward you.
2. Remove the two Phillips PM2.0×7.0 screws that secure the display assembly to the computer.
3. Turn the computer display-side up, with the front toward you.
4. Open the computer until the display assembly is in an upright position.
44 Chapter 5 Removal and replacement procedures ENWW
To Next Page
Loading...
