Remove the Mini PCI card module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE The wireless antenna cables are available in the Wireless Antenna Kit, spare part
number 441639-001.
NOTE The black WLAN antenna cable is connected to the WLAN module “Main” terminal.
The gray WLAN antenna cable is connected to the WLAN module “Aux” terminal.
2. Spread the retaining tabs (2) on each side of the Mini PCI card module socket to release the Mini
PCI card module. (The edge of the module opposite the socket rises away from the computer.)
3. Remove the Mini PCI card module (3) by pulling the module away from the socket at an angle.
NOTE Mini PCI card modules are designed with a notch (4) to prevent incorrect
installation.
Reverse this procedure to install a Mini PCI card module.
ENWW Component replacement procedures 35
To Next Page
Loading...
