12. If it is necessary to replace the display inverter, disconnect the display panel cable (1) and the
backlight cable (2) from the inverter.
13. Remove the display inverter (3).
NOTE The display inverter is available using spare part number 441628-001.
14. If it is necessary to replace the display panel, remove the four Phillips PM2.5×6.0 screws (1) that
secure the panel to the display enclosure.
15. Remove the display panel (2).
NOTE The display panel is available using spare part number 440711-001.
16. If it is necessary to replace either of the display hinges, remove the four Phillips PM2.0×3.0 screws
(1) that secure each hinge to the display panel.
ENWW Component replacement procedures 47
To Next Page
Loading...
