Processor
NOTE All processor spare part kits include thermal paste.
Description Spare part number
Intel Pentium M 770 2.13-GHz processor 440717-001
Intel Celeron M 360 1.40-GHz processor 438554-001
Before removing the processor, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
Battery on page 29).
5. Remove the following components:
a. Hard drive (see
Hard drive on page 30)
b. Memory/Mini PCI card module compartment cover (see
Memory module on page 32)
c. Optical drive (see
Optical drive on page 36)
d. Switch cover (see
Switch cover on page 38)
e. Keyboard (see
Keyboard on page 40)
f. Display assembly (see
Display assembly on page 44)
g. Base enclosure (see
Base enclosure on page 49)
h. Fan assembly (see
Fan assembly on page 52)
i. Heat sink (see
Heat sink on page 53)
Remove the processor:
1. Use a flat-bladed screwdriver to turn the processor locking screw (1) one-half turn counterclockwise
until you hear a click.
ENWW Component replacement procedures 55
To Next Page
Loading...
